Axel AX4000 User's Manual Manuel d'utilisateur télécharger pdf (Page 19)

Setting-Up the Office Server in Interactive Mode

AXEL Office Server 13

An administrator switch is located on the Office Server rear panel. To enable

set-up mode press then release this switch.

The set-up main menu is displayed on the character terminal.

The following section describes the use of set-up mode.

When the set-up session has been completed, the admin port can be used for

other network services.

Note: during set-up mode, the two leds of the admin port remain lit. For the

AX4020, the "conf." led is also lit.

2.1.2 - From a telnet Session

To run set-up within a telnet session, the IP address of the Office Server must

already be set. This can be done either:

- through a serial terminal, plugged into the admin port (see chapter 2.1.1),

- by specific embedded protocols, using the Ethernet address (see

appendix A.6).

Run the telnet session from any network host. Use 4096 as the telnet port. For

example: under UNIX (where name is the Office Server hostname):

$ telnet name 4096 <CR>

The set-up main menu will then display on the console.

The following section describes the use of set-up mode.

When the set-up session has been completed, the Office Server automatically

terminates the telnet session.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 101 102

Pas de commentaire

Axel AX4000 User's Manual Manuel d'utilisateur Page 19