Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Guide de l'utilisateur télécharger pdf (Page 118)

Downloading Firmware

________________________________________________________________

116 TCP/IP AXEL Platine Terminal

An automatic connection to the tftp host will then be established in order to

download the firmware file (see previous chapter).

If any problems occur, refer to the next chapter.

11.4 - IN CASE OF PROBLEMS

This chapter discusses possible problems. The error list is not exhaustive ; if an

unlisted error occurs, please contact your AXEL distributor.

After an error, the AX3000 should be power-cycled.

11.4.1 - Bootp Stage

If an error occurs, the following message is displayed on the AX3000 monitor:

Bootp errno: xxx

xxx

is the error number.

Possible errors:

0: Ethernet board not responding.

1: no response to the bootp broadcast request (the bootp host is

unreachable or not correctly set-up).

Note: a bootp error does not erase the AX3000 firmware.

11.4.2 - Tftp Stage

A tftp error message can originate from either the tftp host or the AX3000.

Depending on the error, the AX3000 firmware may be erased. If this happens

the firmware downloading will be automatically run (bootp+tftp protocol) the

next time the AX3000 is power-cycled.

Tftp Host Errors:

tftp errno: xxx label

1 2 ... 113 114 115 116 117 118 119 120

Pas de commentaire

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Guide de l'utilisateur Page 118