Axel AX3000 65 User's Manual Manuel d'utilisateur télécharger pdf (Page 25)

Initial Power-On

AX3000 - User's Manual 13

The stages are:

- checking the network (link)

- DHCP request sent to obtain an IP address (and other parameters)

- Terminal contacts the AxRM server

- Firmware file sent (if required), followed by a reboot

- Configuration file sent, followed by a reboot

2.2.1 - Stage 1: Checking the Network

When the terminal is powered up the network connection is tested. The terminal

displays ‘Checking Network Link’. If a network connection is detected, a

message ' Auto-Conf' is shown. The terminal passes to stage 2.

Auto-conf.

2.2.2 - Stage 2: Sending DHCP requests

To obtain an IP address (and possibly of other parameters) a DHCP request is

sent. If a DHCP server is available its IP address is shown in the status line:

Auto-conf. / DHCP: aaa.bbb.ccc.ddd /

The terminal passes to stage 3

2.2.3 - Stage 3: Sending requests to AxRM

After obtaining an IP address via DHCP negotiation the terminal must start

communicating with the AxRM server.

This presents a challenge because the terminal must determine both the IP

address and the TCP port of the AxRM server.

The preferred way is to set the DHCP server to send this information in addition

to the AX3000 IP address. This information (IP address and port) can easily be

entered into the DHCP server by using "Axel DHCP option".

For more information about "Axel DHCP option" please consult the Appendix

A.6.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 275 276

Pas de commentaire

Axel AX3000 65 User's Manual Manuel d'utilisateur Page 25