Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Manuel d'utilisateur télécharger pdf (Page 229)

Appendix

TCP/IP AX3000 User's Manual 219

The AX3000 will not transmit data for printing if the printer handles only the

"Busy" signal,

This parameter determines whether the "Select-In" and/or "Paper Empty"

signals will be selected in addition to the "Busy" signal (which is always used).

Note: the signal modification takes immediately effect.

A.10.13 - The 'Operating Mode' Parameter

This parameter is common to all TCP/IP AX3000 models.

Data is usually sent to the parallel port through a method based on 'interrupts'.

This makes efficient use of the AX3000 CPU.

In event of problems (no printing or a very slow printing), it is possible to change

this parallel port management and to send data by a 'polling' method. To enable

this method, set the "Operating Mode" parameter to "Standard".

Note: the parallel port management modification takes immediately effect.

A.11 - DEFAULT FACTORY SET-UP AND QUICK SET-UP

Quick Set-Up allows an AX3000 to be rapidly updated for immediate use.

Two steps can be distinguished during the terminal reset:

- AX3000 default settings are loaded,

- the AX3000 settings are updated with the quick set-up information.

In the list below the parameters shown in bold type are issued from the quick

set-up.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 239 240

Pas de commentaire

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Manuel d'utilisateur Page 229