Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Manuel d'utilisateur télécharger pdf (Page 31)

Interactive Set-Up

TCP/IP AX3000 User's Manual 21

a) "Enable DHCP" is set to "No"

Only the 'AX3000 IP Address' and 'AX3000 Netmask' parameters are

available. These two parameters MUST be entered.

b) "Enable DHCP" is set to "Yes"

The 'AX3000 IP Address' field is inaccessible and the following DHCP Option

List allows certain parameters to be automatically assigned by DHCP:

- AX3000 Netmask,

- Default router: see Chapter 3.2.4,

- DNS Servers: see Chapter 3.2.2,

- 1st DNS Search Domain: see Chapter 3.2.2.

The "AX3000 Name (FQDN)" (Fully Qualified Domain Name) is an optional

parameter allowing an AX3000 to be identified by this name if both a DHCP

server and a Dynamic DNS server are available. At the boot time the AX3000

broadcasts a DHCP request to obtain its IP address. Within this DHCP request

the AX3000 specifies its name. If the DHCP server is correctly set, it will both

give an IP address to the AX3000 and inform the DNS server a new device is

available. Refer to Figure 1.1, the AX3000 name is "ax3001.terminals.axel.com"

and its IP address is 192.168.1.245.

When <Space> is pressed on "Enhanced Parameters" a dialog box as shown

below is displayed:

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 239 240

Pas de commentaire

Axel AX3000 Platine Terminal Ethernet TCP/IP 65E Manuel d'utilisateur Page 31